Modem Information page MIB variables description 58Model 1001MC Operations Guide 4 • Model 1092ARC managementNote Setting the Rack Protection Mode to normal(0) will enable the rack toreceive new configurations through the global configuration command.Submit buttonAfter you have defined the number of power supplies installed in the rack and the rack protection mode, clickon the Submit button to save the changes.Power Supply 1 StatusDisplays the current status of power supply 1 as one of the following:• available(0)—The power supply is working normally.• down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. Thisstatus listing will also be highlighted in red.• notInstalled(2)—The power supply has not been installed.Power Supply 2 StatusDisplays the current status of power supply 2 as one of the following:• available(0)—The power supply is working normally.• down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. Thisstatus listing will also be highlighted in red.• notInstalled(2)—The power supply has not been installed.Clear Rack X Alarms (clearAlarms)Click on this button to clear alarms for the current rack.Note The System Log will still display the errors after the Clear Rack XAlarms button is clicked.Note The following information describes each column of the modemtable. Each table heading is a hyperlink to a help page that containsinformation about the column.Card Address (nmsSlotID)This variable defines the address of the card. The Model 1001MC will poll the cards using the addresses listedin the Card Address column. If a modem is found with the same address, it will be displayed in that row. Theaddress of the card is set up using the DIP-switches on the card. The address is also a hyperlink to the Model1092ARC Configuration Slot page. This page can be used to set slot-specific information about the card.Line StatusThe line status column on each View Rack page shows the current line status of each card. Keep in mind thatthe more cards the 1001MC is managing, the longer it will take for the line status field to update. Displays thestatus of the line. The following values can be displayed:• startup(1)• dataMode(2)—When the line status is dataMode(2), the units are linked-up and ready to send data.
