Patton electronics NetLink 1001MC Operation Manual

Contents

System Level Information 235Model 1001MC Operations Guide 10 • HTTP/HTML web page referenceImport ConfigurationTo import a configuration file into the access server, type the complete path and filename for the configurationfile you wish to load or click on the Browse… button to select the desired file, then click on the Submit Querybutton (see figure 114 on page 233).Upon successfully importing the file, the access server will display Configuration Load Complete, indicating thatthe new operating parameters have been loaded into flash memory.Click on HOME under the Configuration Menu, then click on the Hard Reset button under Immediate Actions.Note Do not select Record Current Configuration after importing configurationparameters.System Level InformationClicking the Configure Cards hyperlink on the HOME page displays the System Level Information page.Figure 113 displays a portion of the information page for the NetLink system being managed. The System LevelInformation page contains statistical information about the entire system and explains how that information isbroken down among the racks. Each rack can be enabled or disabled from this level. When a rack is disabled, the1001MC stops polling the addresses contained in the specified rack. The 1001MC’s ability to stop polling is use-ful when installing less than eight racks or when taking cards offline in order to perform servicing. The modemsinstalled in the system will continue to operate at the last setting provided. This page also allows you to clearalarms on a per-rack or system basis. Each rack view also contains a View Rack hyperlink to the Modem Informa-tion page (see section “Modem Information Rack X” on page 239 for more information). The following sectionsdescribe the variables contained within the System Level Information page.System OverviewThis section of the System Level Information window (see figure 113 on page 232) does the following:• Displays status information compiled from all Model 1001 racks in the system• Provides several test patterns for use when running diagnostics in system test mode• Enables you to apply global system configurations to Model 1095RC, 2701RC, and 2707RC rack cardsinstalled in the systemApply System ConfigurationIf you are applying a global configuration to all Model 1095RC, 2701RC, and 2707RC rack cards in the sys-tem, select the desired template from the pop-up menu, then click the Apply Configuration button. For moreinformation about the system configuration feature (including how to protect rack cards and racks from beingmodified), refer to section “System Config” on page 259.