System Level Information 236Model 1001MC Operations Guide 10 • HTTP/HTML web page referenceApply System Test ModeIf you are going to be running in system test mode, select one of the following test patterns from the pop-upmenu, then click the Apply Test Mode button.Note The Model 2707RC operates only in the local loopback lal(4) mode.• off(0)• five11(2)—511 is the pattern that is used when the pattern generator and detector are turned on• five11er(3)—511 with errors is the pattern that is used when the pattern generator and detector are turned on• lal(4)—Local loopback• lalWith511(5)—Local loopback with pattern generator set to output 511 pattern• lalWith511er(6)—Local loopback with pattern generator set to output 511 pattern with errors• rdl(7)—Remote digital loopback• rdlWith511(8)—Remote digital loopback with pattern generator set to output 511 pattern• rdlWith511er(9)—Remote digital loopback with pattern generator set to output 511 pattern with errorsTotal Slots Available (totalConfigSlots)Displays the number of configurable slots available in the system.Total Cards Installed (totalActiveSlots)Displays the number of cards the system has found.Power Supplies Installed (boxPowerSupplies)Displays the number of power supplies installed in the system.Total System Warnings (boxWarningNumber)Displays the number of warnings that have been generated by the system.Total System Errors (boxErrorNumber)Displays the number of errors that have been generated by the system.Clear All System Alarms (clearAlarms)Click on this button to clear alarms for the entire system.Note The System Log will still display the errors after the Clear All Sys-tem Alarms button is clicked.Rack X Top LevelThe following variables are used by each rack in the system. Replace the X shown in the variable name with theappropriate rack number to label the specific variable name (i.e. rack2Enable).
