4 APPENDIX A: MESSAGE CODESThis table lists the vendor unique message codes that are returned by the REQUEST SENSE command inthe Field Pointer field (bytes 16-17) when the SKSV bit is 0.GOOD_STATUS 00h General All Seems WellBUSY_STATUS 01h General BusyILLEGAL_COMMAND_STATUS 02h General Illegal commandCOMMAND_ABORTED_STATUS 03h General Command abortedBAD_STATUS 04h GeneralFAILED_STATUS 05h GeneralILLEGAL_MESSAGE 06h General Illegal messageLOGICAL_EW_STATUS 07h GeneralBOP_STATUS 08h GeneralREWRITE_RECOVERED_STATUS 09h GeneralSCSI_BOR_ERR 0Ah SCSI Ring buffer record missing BOR flagSCSI_CRC_ERR 0Bh SCSI Error correction of tape data failedSCSI_INDETERMINATE_IRQ 0Ch SCSI SCSI - Unknown IRQ occurredSCSI_CHIP_INITIALIZE_TIMED_OUT 0Dh SCSI SAPI initialization timed out.SCSI_KERNEL_MSG_FAILED 0Eh SCSI Receiving kernel message failedSCSI_UNKNOWN_BE_STATE_00 0Fh SCSI Unknown BE stateSCSI_UNKNOWN_FE_STATE_00 10h SCSI Unknown FE stateSCSI_UNKNOWN_SCSI_INT 11h SCSI Kernel Message: Unknown SCSI interrupt (unknown SCSI kernelmessage type)SCSI_UNKNOWN_KERNEL_MSG_TYPE 12h SCSI Kernel Message: Unknown kernel message typeSCSI_UNKNOWN_SENDER 13h SCSI Kernel Message: Unknown kernel message senderSCSI_UNKNOWN_SCSI_MSG 14h SCSI Kernel Message: Unknown SCSI messageSCSI_UNKNOWN_SVA_MSG 15h SCSI Kernel Message: Unknown SERVO ALERT messageSCSI_UNKNOWN_DMA_MSG 16h SCSI Kernel Message: Unknown DMA messageSCSI_TIMER_FAILED 17h SCSI Timer failedSCSI_ZERO_TRANSFER 18h SCSI SAPI transfer with zero lengthSCSI_UNEXP_CCSTARTED_00 19h SCSI Unexpected COMMAND COMPLETE startedSCSI_UNEXP_CCNOTSTARTED 1Ah SCSI Unexpected COMMAND COMPLETE not startedSCSI_FE_STATE_NOT_MATCHED_00 1Bh SCSI SCSI - unexpected FE state at checkpoint 00SCSI_UNEXP_SELFTEST_MODE 1Ch SCSI Unexpected Self Test modeSCSI_ABORT_BIT_SET 1Dh SCSI Unexpected ABORT bit setSCSI_NON_DSM_PRIMITIVE 1Eh SCSI Unexpected DSM primitiveSCSI_CMD_REFS_EXHAUSTED_00 1Fh SCSI SCSI Task command references exhausted at checkpoint 00.SCSI_UNKNOWN_INQ_PAGE 20h SCSI Unknown Inquiry pageSCSI_UNKNOWN_IID 21h SCSI Unknown initiator idSCSI_UNKNOWN_SENSE_TYPE 22h SCSI Unknown sense typeSCSI_DMA_FIFO_ERR 23h SCSI Ultra 2 DMA overrun/underrunSCSI_DMA_OFFSET_ERR 24h SCSI Ultra 2 offset errorSCSI_DMA_PARITY_ERR 25h SCSI Ultra 2 DMA parity errorSCSI_READ_PARITY_ERR 26h SCSI Read parity errorSCSI_OFFSET_ERR 27h SCSI SCSI offset errorSCSI_UNKNOWN_MODE_PAGE 28h SCSI Unknown Mode pageSCSI_EJECT_FAILED 29h SCSI EJECT failedSCSI_ILLEGAL_MSG_SEQ 2Ah SCSI Illegal SCSI bus message sequenceSCSI_ILLEGAL_DSM_CMD 2Bh SCSI DSM sent invalid command at checkpointSCSI_BUSY_STATUS_FAILED 2Ch SCSI Not usedSCSI_UNEXP_CMD_REF 2Dh SCSI Unexpected Command reference foundSCSI_ILLEGAL_MON_CMD 2Eh SCSI Illegal command returned from MON TaskSCSI_DSM_TIMEOUT 2Fh SCSI SCSI Task timed a message to DSMSCSI_KERNEL_MSG_TIMEOUT 30h SCSI Receiving kernel message timeoutSCSI_FW_DOWNLOAD_FAILED 31h SCSI Microcode load failure, unable to flashSCSI_UNKN_CMD_REF_TYPE 32h SCSI Unknown Command Reference Type
