Chapter 3 Configuring Your LibraryConfiguring System SettingsScalar i500 User’s Guide 131Auto-Ticket Closure 3 For information about this feature, see Closing RAS TicketsAutomatically on page 491.Configuring the Libraryfor FIPS 3 To configure your library for FIPS, perform the following steps:1 Upgrade library firmware to version 600G or later.2 For all HP LTO-5 FC tape drives that you plan to enable for FIPS,upgrade firmware to the latest version qualified with the Scalar i500library (see the Scalar i500 Release Notes for qualified firmware levels).3 Shut down the library.4 Do one of the following:5 Power on the library.6 Install Storage Networking and Encryption Key Managementlicenses on the library, if they are not already installed.7 Enable FIPS mode (see Enabling and Disabling FIPS Mode on HPLTO-5 Tape Drives on page 131).Enabling and DisablingFIPS Mode on HP LTO-5Tape Drives 3To operate your HP LTO-5 Fibre Channel tape drives to be compliantwith FIPS, you must enable “FIPS mode.” FIPS mode is configured bypartition. You enable FIPS mode on a partition, which enables FIPS modeon all of the tape drives in the partition.To change FIPS mode for a partition:1 On the library web client, select Setup > Encryption > PartitionConfiguration.The Setup - Encryption Partition Configuration page displays (seeFigure 16 on page 132).If your library is... Do this...5U Perform Cabling a 5U Library for EthernetConnectivity on page 466.14U or larger Perform Installing the Ethernet ExpansionBlade on page 467.
