Chapter 4 Advanced ReportingWorking With Advanced Reporting ReportsScalar i500 User’s Guide 138• Grouping — Specifies which tape drive(s) or partition(s) to include inthe report. Select one of the following:• All Drives by Coordinate (default) — Presents the sum total ofthe selected Attribute for all tape drives according to theirlocation in the library. If more than one tape drive resided in thatlocation during the selected Date Range, then the Attributevalues for all the tape drives that resided in that location arecombined in the chart.• All Drives by Physical SN — Presents the sum total of theselected attribute for all drives according to the physical tapedrive serial number.• All Partitions — Presents a comparison of all drives grouped bypartition in the physical library.• Selected Drive by Coordinate — The report chart is based on anindividual tape drive location in the library. If more than onetape drive resided in that location during the selected DateRange, then the attribute values for all the tape drives thatresided in that location are combined in the chart.• Selected Drive by Physical SN — The report chart is based on anindividual tape drive identified by its physical drive serialnumber.• Selected Partition — The report chart is based on an individualpartition in the physical library.You can only access this report from the Web client. The path to open thereport is Reports > Advanced Reporting > Drive Resource Utilization.Configuring the MediaIntegrity Analysis Report4 This report provides TapeAlert counts for various combinations of tapedrives, tape cartridges, and TapeAlert flags. You can use this report tohelp determine if a problem is due to a specific tape drive or tapecartridge.The report displays the number of TapeAlerts for the selected Groupingand combination of Attributes. Additionally, the downloaded reportincludes the last 10 tape drive error codes for each TapeAlert, displayedin columns with the headings Error #1, Error #2, and so on. (The onscreenreport does not contain the tape drive error codes.)
