Chapter 10 Getting Information – Logs and ReportsViewing, Saving, and E-mailing Library LogsScalar i500 User’s Guide 277• Location — Location coordinates of the slot. (For a description oflocation coordinates, see Understanding the Location Coordinates onpage 32.)• Element Address — Element address of the slot.• Encryption — The encryption state of the media in the slot. In orderfor the library to know the encryption state, the tape must have beenplaced into an encryption-capable tape drive in the library. Theencryption-capable tape drive reads and records the encryption stateof the tape, and the encryption state displays as “Encrypted” or “NotEncrypted.” If the tape was not placed into an encryption-capabletape drive in the library, or if the slot is empty, the encryption statedisplays as “Unknown.”• Get Count — The number of times the picker successfully removed atape from the slot.• Get Retries — The number of times the picker had to perform arecovery operation to remove a tape from the slot.• Put Count — The number of times the picker successfully placed atape into the slot.• Put Retries — The number of times the picker had to perform arecovery operation to place a tape into the slot.The path to open the report from the Web client is Reports > All Slots.Viewing, Saving, and E-mailing Library LogsThe library collects specific information in log files that you can viewonscreen, save to your computer, or e-mail to a recipient. The followinglibrary logs are available:• Installation Verification Test Summary Log — This log is saved eachtime you run the Installation Verification Test (IVT). The log savesonly the information from the most recently run test. If you run theNote: “Get” and “put” counts and retries are counted from thebeginning of library use to the present. If the LCB compactflash card is replaced, the count starts over at zero.
