Chapter 12 Installing, Removing, and ReplacingReplacing the Control ModuleScalar i500 User’s Guide 391Preparing to Use theControl Module 12 1 Close the library’s I/E station and access doors.2 Add the tape drives to the modules. For details, see Adding,Removing, and Replacing Tape Drives on page 444.3 Add the power supplies. For details, see Adding, Removing, andReplacing Power Supplies on page 420.4 Install the LCB or compact flash card from the removed controlmodule in the new control module. For details, see Removing andReplacing the Library Control Blade and LCB Compact Flash Card onpage 408.5 Connect all power cords, network data cables, and module-to-module cables. Make sure the module terminators are installed intheir previous positions at the top and bottom of the stack ofmodules. For cabling instructions, see Cabling the Library onpage 293.6 Power on the library.7 Re-create and/or modify partitions, cleaning slots, and I/E stationslots as desired.8 Import tape cartridges into the correct partitions as needed.9 Save the library configuration (see Saving the Library Configurationon page 495.10 If the host application inventories the location of each tape cartridgein the library, open the host application and reinventory in order tosync its logical inventory with the physical inventory of the library.Due to the way the library logically addresses its tape drives and slotsinternally, replacing a control module may change the elementaddresses, and this can affect proper communication to a controllinghost. See Understanding Logical Element Addressing on page 35.Because of this, you must refresh the configuration of any backupapplication that manages the library to reflect the adjusted positions.In addition, you may need to reboot the host server(s) or rescan thebus to detect the changes.
