SAMSUNG ProgrammingDCS-816 February, 1999MMC 508 (Page 1 of 2)MMC: 508 CALL COSTDESCRIPTION:Allows the system administrator to set the Call Cost attributes generated by thesystem during a call. This information can be displayed on the keyset LCD during acall or as an SMDR record.Attributes are as follows:0 UNIT COST PER MP When the system is installed to receive MP on a C.O.outgoing call. It is used for generating total call cost bymultiplying it by the number of pulses. Allows amaximum value of 5000.1 CALL COST RATE This generates additional call cost calculated bymultiplying this rate by the original call cost. Rangesfrom 100 through 255.WARNING• Changing this value when there is a call in progress may result in an inaccuratecall cost.• This MPD facility requires the Meter Pulse Detection version of the trunk card. Itis not available on the standard product.PROGRAM KEYSUP & DOWN Used to scroll through optionsKEYPAD Used to enter selectionsSOFT KEYS Move cursor left and rightSPK Used to store data and advance to next MMCACTION DISPLAYUNIT COST PER MP0200 PENCE→1. Press TRSF 508Display shows2. Dial 0 or 1 (e.g. 1)ORCALL COST RATE100% →_Press UP or DOWN key for selection and pressRIGHT soft key to move cursor3. Enter new value (e.g. 110 for 110 percent)System returns to step 2CALL COST RATE110% →4. Press TRSF to store and exitORPress SPK to store and advance to next MMC