Samsung DCS-816 Programming Manual

Also see for DCS-816: Programming manual Programming manual User guide Installation manual Installation manual

Contents

SAMSUNG System Administration and Special Features GuideDCS-816 February, 19991 - 21.6 EXECUTIVE BARGE-INIf you want to break into another station's conversation, you must be allowed to barge-inand the other station must not be secure.• Dial the desired extension number and listen for the busy signal.• Press the BARGE-IN key and begin speaking after the tone.• Hang up when you are finished.The system can be set for one of the three following barge-in options:• No barge-in allowed• Barge-in with intrusion tone• Barge-in without intrusion tone (service observing)When this last option is selected, the station that barges-in can monitor the conversationand no warning tone or display will be sent to the station being monitored. The handsettransmitter and keyset microphone (if equipped) are disabled. The party that originated thebarge-in may join the conversation by pressing the MUTE key on the keyset.Your service company must program these options for you.1.7 WALKING CLASS OF SERVICEYou can change a restricted station's class of service to the same class that your station isin, allowing you to make calls or use features that would otherwise be restricted from thatstation.• Lift the handset or press the SPK key.• Dial 59 and then your extension number.• Dial your station passcode and receive internal dial tone.• Dial an access code and then the telephone number -OR- use the desiredfeature as usual.• Hang up. The station will be returned to its restricted statusNOTE: The default station passcode 1234 cannot be used1.8 IN/OUT OF GROUPAny station assigned to a station group can leave that group and then reenter the group ata later time. When out of the group, a station can receive calls to its extension number butnot to the group. There are 10 groups and the access codes are 500-509.To create a backup or relief operator position, assign the main operator and one or morebackup individuals to the operator group. All but the main operator should be out of thegroup. When it is necessary to use a backup operator, put the desired backup station inthe group and remove the main operator. When incoming call traffic is heavy, you canhave another station put itself in the operator group along with the main operator to handlethe extra call load.If the station does not have an IN/OUT key:• Lift the handset and dial 53.• Dial the group number.• Dial 0 to be out of the group -OR- dial 1 to be in the group.