Sanyo PLC-WTC500AL - 5000 Lumens Manual

Also see for PLC-WTC500AL - 5000 Lumens: Owner's manual Specifications Manual

Contents

Sanyo PLC-WTC500AL - 5000 Lumens Manual Manual pdf 10 page image

PLC-WTC500L Expand Serial Command Functional Specifications10/755 Functional Execution Command Table5.1 Image Command TableExecute command ItemCF_BRIGHT_%1 [CR] Set value of BrightnessCF_CONT_%1 [CR] Set value of ContrastCF_COLOR_%1 [CR] Set value of ColorCF_TINT_%1 [CR] Set value of TintCF_SHARP_%1 [CR] Set value of SharpnessCF_GAMMA_%1 [CR] Set value of GammaCF_WBAL-R_%1 [CR] Set Red value of White BalanceCF_WBAL-G_%1 [CR] Set Green value of White BalanceCF_WBAL-B_%1 [CR] Set Blue value of White BalanceCF_COLTEMP_%1 [CR] Set level of Color TemperatureCF_NZRED_%1 [CR] Set ON/OFF of Noise reductionCF_PROGV_%1 [CR] Set mode of Progressive scanCF_IMAGE_%1 [CR] Set Image modeCF_IMAGEADJ_%1 [CR] Set Store/Reset of values in Image Adjustment5.2 PC Adjust Control Command TableExecute command ItemCF_FSYNC_%1 [CR] Set value of Fine SyncCF_TDOTS_%1 [CR] Set value of Total DotsCF_CLPPHASE_%1 [CR] Set value of Clamp PhaseCF_H-POS_%1 [CR] Set value of Horizontal PositionCF_V-POS_%1 [CR] Set value of Vertical PositionCF_DDOTS_%1 [CR] Set value of Display DotsCF_DLINE_%1 [CR] Set value of Display LineCF_SETPCADJ_%1 [CR] Apply values set in PC Adjust menu to screen imageCF_ORGMODE_%1 [CR] Specify the original signal for PC modeCF_PCSTORE_%1 [CR] Store current setting values in PC Adjust menu to Mode %1CF_PCMODEFREE_%1 [CR] Delete the values registered in Mode %1 and return it toFree status.5.3 Input Control Command TableExecute command ItemCF_INPUT_%1 [CR] Select InputCF_SOURCE_%1 [CR] Select Source of selected InputCF_INPUT1_%1 [CR] Select Input1 and also set input source to %1CF_INPUT2_%1 [CR] Select Input2 and also set input source to %1CF_INPUT3_%1 [CR] Select Input3 and also set input source to %1CF_INPUT4_%1 [CR] Select Input4 and also set input source to %1CF_SYSTEM_%1 [CR] Select System of currently selected Input