Sanyo PLC-WTC500AL - 5000 Lumens Manual

Also see for PLC-WTC500AL - 5000 Lumens: Owner's manual Specifications Manual

Contents

Sanyo PLC-WTC500AL - 5000 Lumens Manual Manual pdf 40 page image

PLC-WTC500L Expand Serial Command Functional Specifications40/758.10.17 CF_SLANT CommandCommand “CF_HIGHLAND_%1”[CR]%1“OFF” ----------------- Install a projector at L3 degree angle in front projection,or at L4 degree angle in ceiling projection“L1” ------------------- Slant a projector at L1 degree angle“L2” ------------------- Slant a projector at L2 degree angle“L3” ------------------- Install a projector at L3 degree angle in Ceiling projection“L4” ------------------- Install a projector at L4 degree angle in front projection“UP” ------------------ Switch forward (Off -> L1 -> L2 -> L3 -> L4 -> Off)“DN” ------------------ Switch backward (Off -> L4 -> L3 -> L2 -> L1 -> Off)DetailsSwitch slant of the projector installed.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFF.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.18 CF_SHUTRCPROT CommandCommand “CF_SHUTRCPROT_%1” [CR]%1 “ON” ------------------ Disable RC key from controlling Shutter (Protection On)“OFF” ----------------- Enable RC key to control Shutter (Protection Off)Details Set valid / invalid of RC use on Shutter control function(Valid only when in the normal Power ON status)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.19 CF_SHUTKEYPROT CommandCommand “CF_SHUTKEYPROT_%1” [CR]%1 “ON” ------ Disable key on the top panel from controlling Shutter (Protection On)“OFF” -------- Enable key on the top panel to control Shutter (Protection Off)Details Set valid / invalid use of key on the top panel on Shutter control function.(Valid only when in the normal Power ON status)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.20 CF_SHUTH CommandCommand “CF_SHUTH_%1” [CR]%1“005”-“180”----------Specify setting time directly“UP” ------------------ Add 1 minute“DN” ------------------Decrease 1 minuteDetailsSet time of operating shutter management function.(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]