Sanyo PLC-WTC500AL - 5000 Lumens Manual

Also see for PLC-WTC500AL - 5000 Lumens: Owner's manual Specifications Manual

Contents

Sanyo PLC-WTC500AL - 5000 Lumens Manual Manual pdf 39 page image

PLC-WTC500L Expand Serial Command Functional Specifications39/758.10.13 CF_P-MANE CommandCommand “CF_P-MANE_%1” [CR]%1“OFF” ---------------------------------- Set Power Management to Off“READY” ----------------------------- Set Power Management to Ready“SHUTDOWN” --------------------- Set Power Management to Shut Down mode“UP” ----------------------- Switch forward (Off→Ready→Shut down→Off)“DN” ---------------------- Switch backward (Off→Shut down→Ready→Off)DetailsSet/Cancel Power Management(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.14 CF_P-MANETIME CommandCommand “CF_P-MANETIME_%1” [CR]%1“01” - ”30” ----------------------- Directly specify setting time by the minute“UP” -------------- Increment value by 1 (Switched in 01→02→ --- → 30 → 01 order)“DN” -------------- Decrement value by 1(Switched in 30→29→ --- → 01 → 30 order)DetailsSet time of Power Management time (Available only in the normal Power ONstatus)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.15 CF_ON-STA CommandCommand “CF_ON-STA_%1” [CR]%1“ON” --------------------------- Set Power On Start to ON.“OFF” ------------------------- Set Power On Start to OFF.“UP” ---------- Toggle between ON and OFF.(On→Off→On → - - -)“DN” --------- Toggle between ON and OFF.(On→Off→On → - - -)*”UP” and “DN” are exactly same operation.DetailsSet/Cancel Power ON Start (Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.16 CF_FANSPEED CommandCommand “CF_FANSPEED_%1” [CR]%1 “MAX” ------------------------------ Select maximum fan speed“NOR” ------------------------------ Select normal fan speedDetailsSwitch Fan Control Speed mode.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]