Sanyo PLC-WTC500AL - 5000 Lumens Manual

Also see for PLC-WTC500AL - 5000 Lumens: Owner's manual Specifications Manual

Contents

Sanyo PLC-WTC500AL - 5000 Lumens Manual Manual pdf 19 page image

PLC-WTC500L Expand Serial Command Functional Specifications19/758.4.8 CF_COLTEMP CommandCommand “CF_COLTEMP_%1” [CR]%1“000” ------------------------------ Xlow“001”------------------------------- Low“002”------------------------------- Mid“003”------------------------------- HighDetailsSet Color Temperature (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.4.9 CF_NZRED CommandCommand “CF_NZRED_%1” [CR]%1“OFF” ---------------- Cancel Noise Reduction“L1” ------------------- Set Noise Reduction L1“L2” ------------------- Set Noise Reduction L2“UP” ------------------ Toggle between ON and OFF. (OFF→L1→L2→OFF...)“DN” ------------------ Toggle between ON and OFF. (OFF→L2→L1→OFF...)DetailsSet Noise Reduction level (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memoryTherefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It returns to the original setting in Suspend mode as well.)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.4.10 CF_PROGV CommandCommand “CF_PROGV_%1” [CR]%1“OFF” -------------- Set Progressive scan to OFF.“L1” ----------------- Set Progressive scan to L1 (for movie image).“L2” ----------------- Set Progressive scan to L2 (for still image).“FILM” ------------- Set Progressive scan to Film.“UP” ---------------- Switch setting forward direction (OFF→L1→L2→FILM→OFF)“DN” ---------------- Switch setting backward direction (OFF→FILM→L2→L1→OFF)DetailsSet Progressive scan mode. (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.4.11 CF_IMAGE CommandCommand “CF_IMAGE_%1” [CR]%1“DYNAMIC” ---Dynamic (Fixed value to enable projection with a sharp, powerfulpicture tone)“STAND” -------Standard(Image adjust value is set to factory default for Still Image)“REAL---------- Real (Fixed value to display graphic image with natural tone)“CINEMA”----- Cinema (Fixed value to focus on tone reproduction for movie)“CUSTOM1” ------------- Image1 the value adjusted and stored by user“CUSTOM2” ------------- Image2 the value adjusted and stored by user“CUSTOM3” ------------- Image3 the value adjusted and stored by user