1 – 84Chapter 1 TroubleshootingFIP3.3 Paper Jam/Exit to OCTStep Check Yes NoPossible causes:HVPS/MCU (PL12.1.19)SENSOR OCT (PL23.1.30)ACTUATOR OCT (PL23.1.31)ROLL OCT LOWER (PL23.1.16)ROLL OCT UPPER (PL23.1.36)ROLL PINCH (PL23.1.34)MOTOR ASSY OCT (PL23.1.6)1 Does Error occur, when the power is turned ON? Go to step 2. Go to step 4.2Checking the paper at ACTUATOR OCTOpen COVER REAR.Does the paper remain at ACTUATOR OCT?Remove thepaper, and thengo to step 3.Go to FIP3.13SENSOR OCT.3 Does Error occur, when the power is turned ON? Go to FIP3.13SENSOR OCT. Go to step 4.4Run a test print.Remove Option OCT, and then reinstall it.Does Error still occur, when Test Printing is run in OCTmode?Go to step 5. End of work5Checking transmission of driving forceDo ROLL OCT LOWER, ROLL OCT UPPER and everyGEAR rotate smoothly?Remove COVER OCT (RRP23.4), and turn ROLL OCTLOWER, ROLL OCT UPPER and every GEAR with afinger to check.Go to step 6. Replace the partsdisturbing rotation.6Checking paper transfer at ROLL OCT LOWER andROLL PINCHInsert paper between ROLL OCT LOWER and ROLLPINCH from lower portion of Option OCT.Is the paper transferred smoothly, when turning GEAR19/ 37 (PL23.1.8) counterclockwise with a finger?Go to step 7. Replace the rolldisturbing transfer.7Checking MOTOR ASSY OCTDoes MOTOR ASSY OCT rotate normally?Check using Chapter 2 Diagnostic [OCT Motor Test].Replace HVPS/MCU.(RRP12.10)Go to FIP3.9MOTOR ASSYOCT.
