1 - 128Chapter 3 Removal and Replacement Procedures (RRPs)RRP7.7 SENSOR FULL STACK (PL 7.1.26)Removal1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).2) Remove the COVER REAR (PL 1.1) (RRP1.1).3) Remove the COVER LEFT (PL 1.1) (RRP1.3).4) Remove the COVER RIGHT (PL 1.1) (RRP1.2).5) Remove the COVER EXIT 500 (PL 1.1) (RRP7.1).6) Remove the CHUTE UP EXIT (PL 7.1) (RRP7.3).7) Disconnect the connector (P/J290) of the HARNESS ASSEMBLY EXIT SNR (PL 7.1.27) from theSENSOR FULL STACK (Figure 1).8) Release the hooks of the SENSOR FULL STACK, and remove the SENSOR FULL STACK fromthe CHUTE LOW EXIT (PL 7.1) (Figure 1).Figure 1. Full Stack SensorReplacement1) Install the SENSOR FULL STACK to the CHUTE LOW EXIT (PL 7.1) (Figure 1).2) Connect the connector (P/J290) of the HARNESS ASSEMBLY SNR (PL 7.1.27) to the SENSORFULL STACK (Figure 1).3) Install the CHUTE UP EXIT (PL 7.1) (RRP7.3).4) Install the COVER EXIT 500 (PL 1.1) (RRP7.1).5) Install the COVER RIGHT (PL 1.1) (RRP1.2).6) Install the COVER LEFT (PL 1.1) (RRP1.3).7) Install the COVER REAR (PL 1.1) (RRP1.1).There are 2 kinds of screws, make sure they are installed correctly.8) Install the COVER REAR 500 (PL 7.1) (RRP7.9).
