TallyGenicom 9045N Service Manual

Also see for 9045N: Brochure Brochure & specs Datasheet Quick start guide User guide

Contents

TallyGenicom 9045N Service Manual Manual pdf 325 page image

1 - 141Chapter 3 Removal and Replacement Procedures (RRPs)RRP8.2 MAIN MOTOR (PL 8.1.2)Removal1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).2) Remove the COVER REAR (PL 1.1) (RRP1.1).3) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).4) Remove the COVER LEFT (PL 1.1) (RRP1.3).5) Remove the COVER RIGHT (PL 1.1) (RRP1.2).6) Remove the COVER EXIT 500 (PL 1.1) (RRP7.1).7) Remove the 500 EXIT ASSEMBLY (PL 7.1) (RRP7.2).8) Remove the COVER TOP (PL 1.1) (RRP1.4).9) Remove the COVER FRONT (PL 1.1) (RRP1.5).10) Remove the BTR ASSEMBLY (PL 6.1) (RRP6.9).11) Remove the DUCT FRONT (PL 6.1) (RRP6.2).12) Remove the ROS ASSEMBLY (PL 6.1) (RRP6.1).Be careful not to drop or strike the ROS Assembly with any tools or other objects.13) Remove the SHIELD PLATE ROS (PL 6.1) (RRP6.3).14) Remove the GUIDE TRAY LEFT (PL 5.1) (RRP5.8).15) Remove the MOTOR COVER (PL 8.1) (RRP8.1).16) Remove the SHIELD PLATE LVPS (PL 9.1) (RRP8.1).17) Disconnect the connector (P/J43) of the MAIN MOTOR from the LVPS (PL 9.1.5) and disconnectthe connector (P/J271) (Figure 1).18) Lift up the 150 FEEDER ASSEMBLY (PL 4.1) (Figure 1).The 150 FEEDER ASSEMBLY clicks into a notch when lifted to the half way point, pushthe assembly past the notch.19) Remove the 3 screws (gold, 6mm) securing the MAIN MOTOR to the frame (Figure 1).20) Remove the MAIN MOTOR (Figure 1).Replacement1) Install the MAIN MOTOR to the frame using the 3 screws (gold, 6mm) (Figure 1).2) Connect the connector (P/J43) of the MAIN MOTOR to the LVPS (PL 9.1.5) and connect the con-nector (P/J271) (Figure 1).3) Install the SHIELD PLATE LVPS (PL 9.1) (RRP8.1).4) Install the MOTOR COVER (PL 8.1) (RRP8.1).5) Install the GUIDE TRAY LEFT (PL 5.1) (RRP5.8).6) Install the SHIELD PLATE ROS (PL 6.1) (RRP6.3).7) Install the ROS ASSEMBLY (PL 6.1) (RRP6.1).Be careful not to drop or strike the ROS Assembly with any tools or other objects.8) Install the DUCT FRONT (PL 6.1) (RRP6.2).9) Install the COVER FRONT (PL 1.1) (RRP1.5).10) Install the COVER TOP (PL 1.1) (RRP1.4).11) Install the 500 EXIT ASSEMBLY (PL 7.1) (RRP7.2).12) Install the COVER EXIT 500 (PL 1.1) (RRP7.1).