TallyGenicom 9045N Service Manual

Also see for 9045N: Brochure Brochure & specs Datasheet Quick start guide User guide

Contents

TallyGenicom 9045N Service Manual Manual pdf 251 page image

1 - 67Chapter 3 Removal and Replacement Procedures (RRPs)RRP4.7 SENSOR REGI (PL 4.1.30)Removal1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).2) Remove the COVER REAR (PL 1.1) (RRP1.1).3) Release the hooks securing the COVER SENSOR (PL 4.1), and remove the COVER SENSORfrom the CHUTE ASSEMBLY REGI (Figure 1).4) Release the hooks securing the SENSOR REGI, and remove the SENSOR REGI from theCOVER SENSOR (Figure 1).5) Disconnect the connector (P/J241) of the HARNESS ASSEMBLY TRAY 1 (PL 4.1) from the SEN-SOR REGI.Figure 1. Registration SensorReplacement1) Connect the connector (P/J241) of the HARNESS ASSEMBLY TRAY 1 (PL 4.1) to the SENSORREGI.2) Install the SENSOR REGI to the COVER SENSOR (PL 4.1), and secure it using hooks (Figure 1).3) Install the COVER SENSOR to the CHUTE ASSEMBLY REGI, and secure it using hooks (Figure1).4) Install the COVER REAR (PL 1.1) (RRP1.1)There are 2 kinds of screws, make sure they are installed correctly.5) Install the COVER REAR 500 (PL 7.1) (RRP7.9).