1 - 3Chapter 3 Removal and Replacement Procedures (RRPs)1.4 Description of procedures "RRP X,Y "AAAAA" at the top of procedures represent the part name AAAAA are to be removedand replaced. "(PL X.Y.Z)" following the parts name in procedures represent that the parts are those of the plate(PL) "X.Y", item "Z" in Chapter 5, Parts List. Their forms, replacing position or other conditions canbe seen in Chapter 5, Parts List. In the procedures, directions are represented as follows.- Front: Front when you are facing the front of this laser printer.- Rear: Inner direction when you are facing the front of this laser printer.- Left: Left hand when you are facing the front of this laser printer.- Right: Right hand when you are facing the front of this laser printer. The screws in procedures are expressed with their replacing position, color, characteristics andnominal length, etc. “In case of _____ specifications" in the procedures indicate that service operation should be pro-vided only to laser printer of specified specifications (service operation should not be provided forlaser printer of specifications not covered). "RRP X.Y" in the midst or at the end of sentences in the procedures indicate that work proceduresrelated with the "RRP X.Y" are described. "Figure X.Y" at the end of the sentences of procedures indicate that illustrations instructive for the"RRP X.Y" are included. "Z)" in the illustrations correspond to "Z)" of the service procedures. The screws in the illustrations should be removed using a plus (+) screwdriver unless otherwisespecified. A black arrow in the illustrations indicate movement in the arrow mark direction. Numbered blackarrows indicate movement in the order of the numbers. White arrows (FRONT) in the illustrations indicate the front direction. For the positions of the connectors (P/J), refer to Chapter 7, Electric wiring.JG3205AALEFTFRONTRIGHTREAR
