1 – 20Chapter 1 TroubleshootingFIP1.8 Paper Jam/ExitStep Check Yes NoPossible causes:FUSER ASSY (PL8.1.20)HVPS/MCU (PL12.1.19)HARNESS ASSY FUSER (PL8.1.17)MOTOR ASSY EXIT (PL10.1.15)LVPS (PL12.1.5)ROLL PINCH EXIT (PL10.1.23)500 EXIT ASSY (PL10.1.2)150 PAPER CASSETTE (PL2.1.50)550 PAPER CASSETTE (PL4.1.50)1 Checking the paper condition.Is the paper crumpled, damaged or damp?Replace thepaper with a newand dry one.Go to step 2.2Checking the paper size setup.Does the paper size in use match the size setup byGUIDE ASSY END or by the driver on the PC?Go to step 3.Replace the paper,or set up the papersize correctly.3 Does Error occur when the power is turned ON? Go to step 4. Go to step 6.4 Checking the paper in Actuator Exit.Is there any remaining paper in Actuator Exit?Remove thepaper, and go tostep 5.Go to step 8.5 Does Error occur when the power is turned ON? Go to step 8. Go to step 6.6Run a test print.Does Error occur?Check using Chapter 2 Diagnostic [TEST PATTERNMODE MENU].Go to step 7. End of work7Checking ROLL PINCH EXIT.Remove COVER TOP ASSY (PL1.1.7). (RRP1.4)Is ROLL PINCH EXIT not damaged, and rotatingsmoothly?Does SPRING PINCH EXIT attach?Turn ROLL EXIT with a finger to check.Go to step 8. Replace ROLLPINCH EXIT.8Checking ROLL EXIT (PL10.1.12) for rotation.Remove EP CARTRIDGE.Close COVER OPEN (PL1.1.2).Turn the power ON.Does ROLL EXIT rotate smoothly during warm up?Go to step 9. 500 EXIT ASSY.(RRP10.2)9Checking Actuator Exit for operation.Remove EP CARTRIDGE.Does Actuator Exit move smoothly, when touchingActuator Exit with a finger inserted from the exit ofFUSER ASSY, and moving it up and down?With tool Go tostep 10. Withouttool Go to step11.Replace FUSERASSY. (RRP8.8)10Checking Exit Sensor for operation (1).Remove EP CARTRIDGE.Does the number of Sensor/Switch Check increase byone, every time Actuator Exit is pushed and released?Check using Chapter 2 Diagnostic [Sensor/SwitchCheck].Replace HVPS/MCU.(RRP12.10)Go to step 11.
