1 - 120Chapter 3 Removal and Replacement Procedures (RRPs)RRP7.2 500 EXIT ASSEMBLYRemoval1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).2) Remove the COVER REAR (PL 1.1) (RRP1.1).3) Remove the COVER LEFT (PL 1.1) (RRP1.3).4) Remove the COVER RIGHT (PL 1.1) (RRP1.2).5) Remove the COVER EXIT 500 (PL 1.1) (RRP7.1).6) Remove the SHIELD ASSEMBLY ESS (PL 9.1) (RRP9.7)7) Disconnect the connector (P/J29) of the HARNESS ASSEMBLY EXIT SNR from the HVPS/MCU(PL 9.1.19) (Figure 1).8) Disconnect the connector (P/J103) of the MOTOR ASSEMBLY EXIT from the PWBA EXITMOTOR (PL 9.1.4) (Figure 1).9) Remove the 5 screws (gold with spring washer,10mm,x4,silver 6mm,x1)securing the 500 EXITASSEMBLY to the printer (Figure 1).10) Remove the 500 EXIT ASSEMBLY.Figure 1. 500 Exit AssemblyReplacement1) Put the harnesses of the MOTOR ASSEMBLY EXIT and SENSOR into the hole on the frame (Fig-ure 1).2) Install the 500 EXIT ASSEMBLY using the 5 screws (gold with spring washer,10mm,x4,silver6mm,x1) (Figure 1).3) Connect the connector (P/J103) of the MOTOR ASSEMBLY EXIT to the PWBA EXIT MOTOR (PL9.1.4) (Figure 1).4) Connect the connector (P/J29) of the HARNESS ASSEMBLY EXIT SNR to the HVPS/MCU (PL9.1.19) (Figure 1).5) Install the SHIELD ASSEMBLY ESS (PL 9.1) (RRP9.7).6) Install the COVER EXIT 500 (PL 1.1) (RRP7.1).
