Vacon NX Series Applications Manual
Also see for NX series: User manualUser manualApplications manualMaintenance manualOperating guide
                                                                                                                                                                                                                                                                                                                                                                                           | |
Contents
| 
9 PARAMETER DESCRIPTIONSOn the following pages you find the parameter descriptions arranged according to theindividual ID number of the parameter. An asterisk after the parameter ID number (e.g. 418Motor potentiometer UP *) indicates that the TTF programming method must be applied tothis parameter (see Chapter 9.9 "Terminal to function" (TTF) programming principle).Some parameter names are followed by a number code indicating the "All in One"applications in which the parameter is included. If no code is shown the parameter isavailable in all applications. See below. The parameter numbers under which the parameterappears in different applications are also given.1. Basic Application2. Standard Application3. Local/Remote Control Application4. Multi-Step Speed Control Application5. PID Control Application6. Multi-Purpose Control Application7. Pump and Fan Control Application101 MINIMUM FREQUENCY (2.1, 2.1.1)Use this parameter to set the minimum frequency reference.102 MAXIMUM FREQUENCY (2.2, 2.1.2)Use this parameter to set the maximum frequency reference.Defines the frequency limits of the AC drive. The maximum value for these parameters is 320Hz.Minimum and maximum frequencies set limits to other frequency related parameters (e.g.Preset Speed 1 (ID105), Preset Speed 2 (ID106) and 4 mA fault preset speed (ID728).103 ACCELERATION TIME 1 (2.3, 2.1.3)Use this parameter to set the time that is necessary for the output frequency to increasefrom zero frequency to maximum frequency.104 DECELERATION TIME 1 (2.4, 2.1.4)Use this parameter to set the time that is necessary for the output frequency to decreasefrom maximum frequency to zero frequency.105 PRESET SPEED 1 1246 (2.18, 2.1.14, 2.1.15)Use this parameter to set the preset frequency reference when the preset frequenciesfunction is used.PARAMETER DESCRIPTIONS VACON · 205LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/ 9 |
Related manuals for Vacon NX series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine