4010% S0% SS2 Skip0.000.420.481.261.682.102.522.943.363.784.204.625.045.465.8835302520151050Fig. 90: Ramp; Skip S2Second S curve is bypassed when reference changes at 25 Hz.9.1 KEYPAD CONTROL PARAMETERSUnlike the parameters listed above, these parameters are located in the M3 menu of thecontrol keypad. The frequency and torque reference parameters do not have an ID number.114 STOP BUTTON ACTIVATED (3.4, 3.6)Use this parameter to enable the keypad stop button.If you wish to make the Stop button a "hotspot" which always stops the drive regardless ofthe selected control place, give this parameter the value 1.See also parameter ID125.125 CONTROL PLACE (3.1)Use this parameter to select the control place.The active control place can be changed with this parameter. For more information, see theproduct's User Manual.Pushing the Start button for 3 seconds selects the control keypad as the active control placeand copies the Run status information (Run/Stop, direction and reference).PARAMETER DESCRIPTIONS VACON · 351LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/ 9
