EXAMPLEYou want to connect the digital output function Reference fault/warning (parameter 2.3.3.7)to the digital output DO1 on the basic board OPTA1 (see the product's User Manual).1 Find the parameter 2.3.3.7 on the keypad. Press theMenu button right once to enter the edit mode. Onthe value line, you will see the terminal type on theleft (DigIN, DigOUT, An.IN, An.OUT) and on theright, the present input/output the function isconnected to (B.3, A.2 etc.), or if not connected, avalue (0.#).2 When the value is blinking, hold down the Browserbutton up or down to find the desired board slotand signal number. The program will scroll theboard slots starting from 0 and proceeding from Ato E and the I/O selection from 1 to 10.3 Once you have set the desired value, press theEnter button once to confirm the change.9.9.2 DEFINING A TERMINAL FOR A CERTAIN FUNCTION WITH NCDRIVEPROGRAMMING TOOLIf you use the NCDrive Programming Tool for parametrizing you will have to establish theconnection between the function and input/output in the same way as with the control panel.Just pick the address code from the drop-down menu in the Value column.PARAMETER DESCRIPTIONS VACON · 361LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/ 9
