Installing and Removing the I/O-IPC 35WAGO I/O-SYSTEM 750I/O-IPC-C10E, CANopen Master6 Installing and Removing the I/O-IPCThe I/O-IPC has an elevated generation of heat. Excess heat is drawn off bypassive heat dissipation (aluminum underside of the I/O-IPC and mounting rail).For this reason, the I/O-IPC shall always be mounted on a mounting rail.6.1 Instructions for Installation/RemovalThe following information shall always be observed:WARNINGMoving machine components!Disconnect the power supply from the system on which you wish to mount theI/O-IPC.If these precautions are not observed, there is a danger of moving system parts.NOTICEOpen interface!Unneeded interfaces of the I/O-IPC shall be closed with the accompanyingprotective caps to prevent possible damage caused by electrostatic discharge.NOTICEVentilation of the installation siteWhen installing the I/O-IPC, leave a free space on the sides and above of 40 mmto achieve sufficient heat dissipation. The surrounding temperature at theinstallation site shall not exceed +60 ∞C during operation.ï Select a sufficiently stable mounting rail and use several mounting points(every 20 cm), if applicable, to prevent the I/O-IPC from bending andtwisting the mounting rail.ï When using mounting rails with a height of 7.5 mm, use flat riveting orsunken screws. Otherwise, the I/O-IPC and the connected I/O modulescannot be correctly mounted on the mounting rail.ï Take care that the physical interfaces are not soiled during installation. Thiscan lead to damage and corrosion of the contacts.ï To avoid damage to the I/O-IPC, do not install it within the shear ranges ofmobile systems or machine parts.ï Arrange for an appropriate potential equalization in your system.ï The mounting rails shall be screwed on so that they are grounded at theinstallation site.
