40 Installing and Removing the I/O-IPCWAGO-I/O-SYSTEM 750I/O-IPC-C10E, CANopen Master6.6 Dismounting the I/O-IPCTo replace an I/O-IPC (e.g., in the event of version change), proceed as describedin the following section.CAUTIONHot surface!The I/O-IPC housing may become hot during operation. If the I/O-IPC has beenin operation, allow it to cool off before moving it.6.6.1 Disconnecting Cables and ConductorsTo remove the cables and conductors, proceed as follows:1. Disconnect from the power supply those parts of the system on which youhave mounted the I/O-IPC.2. Disconnect the plugs/sockets from the I/O-IPC interfaces and remove thedata cables.3 Remove the conductors from the first 750 Series I/O Module connected tothe I/O-IPC (A).StopRunU1IDE/PWRIOERRSTARDYRUNU2…Figure 13: I/O-IPC interfacesA
