48 I/O-IPC Start-UpWAGO-I/O-SYSTEM 750I/O-IPC-C10E, CANopen Master8 I/O-IPC Start-Up8.1 Turning the I/O-IPC OnBefore turning the I/O-IPC on, check that youï have installed the I/O-IPC properly (see Section 5.8),ï have connected all the necessary data cables (see Section 5) to thecorresponding interfaces,ï have connected the power supply for the electronics and field supply (seeSection 7),ï have connected the 750-600 End Module (see Section 6.5),ï have performed an appropriate potential equalization on yourmachine/system (see System Description for 750-xxx) andï have performed shielding properly (see System Description for 750-xxx).To turn on both I/O-IPC and connected I/O modules, switch on your power supplyunit. After the initialization phase, the Linux operating system starts, and then theCoDeSys 2.3 programming system. After an error-free system start, the I/O-LEDof the I/O-IPC lights up green.CAUTIONHot surface!The I/O-IPC housing may become hot during operation. If the I/O-IPC has beenin operation, allow it to cool off before moving it.NoteDuring operation, no 750 Series components shall be removed or added since thismay result in a breakdown of the I/O-IPC and/or the connected I/O modules.So that the I/O-IPC can communicate on the LAN, the adjustments describedbelow must also be carried out.
