XEROX WIDE FORMAT COPY SYSTEM Main Menu • 101the media guidelines on the Feed-in Tray. The width sensorseliminate the need for a prescan thereby increasing theoverall throughput of the system resulting in higherproductivity. When this feature is used the operator mustselect the media series, ANSI, ARCH, ISO A, ISO B JIS Band CUSTOM etc since the number of sensors provided cannot monitor every media type.To use the MODE: PRODUCTIVITY: CUSTOM the customsizes must be entered in the CUSTOM MEDIA FORMATS(Menu, CONFIGURATION>COPY OPTIONS).To set the Scanner Control features:1. Press the Menu key. The MAIN MENU screen is displayed.2. Press the Enter key to select CONFIGURATION. TheCONFIGURATION menu screen is displayed.3. Press the Next key until SCANNER CONTROL is highlighted.4. Press the Enter key to select SCANNER CONTROL. TheSCANNER CONTROL screen is displayed.SCANNER CONTROLDOCUMENT RETURN:AUTOSCANMODE:4 FRONTPRODUCTIVITY — ANSI5. Press the Previous or Next key to select the desired feature.6. Press the Enter key to confirm the choice.7. Press the Previous or Next key to select the desired setting.For AUTOSCAN, , you can enable or disable the feature. A check markin the box to the left of the feature indicates that the feature is enabled.Enabled is the factory default setting for these features.For DOCUMENT RETURN, the selections are FRONT and REAR.FRONT is the factory default setting.For MODE: use the Previous or Next keys to select the desired optionthen press the Enter key to confirm the choice.. The options areMANUAL, AUTOWIDTH, AUTOWIDTH/AUTOCENTER, orPRODUCTIVITY. If PRODUCTIVITY is selected, then use the Previousor Next key too select the ANSI, ARCH, ISO A, ISO B, JISB, orCUSTOM setting.Use the CUSTOM setting when documents of mixed series will bescanned in the same job. The CUSTOM selection can only be usedwhen sizes are entered in the CUSTOM MEDIA SIZES (MenuCONFIGURATION>COPY OPTIONS.
