52 •Making copies XEROX WIDE FORMAT COPY SYSTEMimage so that no image rotation is required. This will achieve the fastestprocessing time. For example, if an A-size copy is required on a 12-inch(30.48 cm) roll, feed the original with the short edge first, not the longedge first. If a B-size copy is required on a 17-inch roll, feed thedocument with the long edge first, not the short edge first.The Scanner scans the document and the Printer (if not already busy)prints the copy immediately. If the Printer is busy when the scan ismade, the copy will be printed when the Printer becomes available.When the Scanner detects the trail edge of the document, the Printerautomatically cuts the media so that the copy is the same length as theoriginal document.Fitting the image to a fixed copy sizeThe scanned image can be automatically fit onto a predefined size ofmedia.1. Set the Media Selection, Source to Auto. The Auto indicatorlamp illuminates. This setting automatically selects the availablemedia roll that best fits the image width.2. Select the Media Selection, Type of media. The default settingis Bond.3. Set the Media Selection, Output Format to Preset and selectthe desired page size. This setting cuts the media to apreviously defined length that the operator chooses.PRESET OUTPUT FORMATSELECT 8.5 X 11 ANSI A4. Press the Previous or Next key until the desired output size ishighlighted.5. Press the Enter key to confirm your choice.6. Set the Reduce/Enlarge to Auto.7. Insert the document face down into the Scanner. If the scandoes not start automatically, press the Start key.NOTE: To set the scan to begin automatically, refer to "Scanner Control"in the "Main Menu" section of this manual.The Scanner scans the document, and the Printer (if not already busy)prints the copy immediately. If the Printer is busy when the scan ismade, the copy will be printed when the Printer becomes available.
