I-Class 936.1 Fault and Warning MessagesAll printer functions are internally monitored. If a problem (Fault) or a potentialproblem (Warning) is detected, the Error Indicator (see Section 4.0.4) will beilluminated. A corresponding message will be displayed (if not within a branchof the menu system or in Quick Test Mode). These messages, along withpossible solutions, are described below.Fault Messages:Fault Messages receive the highest display priority. If more than one fault isdetected the display will cycle between messages.˛ Note: To return to normal operation after the printer enters a fault condition,the fault must be corrected and then the FEED Key must be pressed toclear the condition.Printer Fault MessagesDisplayed Message Description Possible Solution(s)The printer hasdetected a drop inthe 24-volt powersupply.Try cycling the printer power‘Off’ and ‘On’. If the faultdoes not clear, call forservice.The printer hasdetected an analogto digital circuitconverter failure.Try cycling the printer power‘Off’ and ‘On’. If the faultdoes not clear, call forservice.The printer hasdetected a cuttermechanism fault.WARNING! Use extremecare. Turn ‘Off’ and unplugthe printer before proceeding.Examine the cutter forobstructions and ensure thatthe cutter cable is properlyinstalled.Plug in and turn ‘On’ theprinter. Press the FEED Key.If the fault does not clear, callfor service.