Xerox I Class Operator's Manual

Contents

106 I-ClassMedia and Ribbon Requirements (continued)EABCDGHIJFMedia DimensionsDesignator Description Maximum [1] Minimum[1]A label width 4.65 1.00B liner width 4.65 1.00C gap (or notch) between labels[4] – .100D label length[4] – .250E media thickness[2] .0100 .0025F notch opening width .500 .200G distance from the media’s edge to themedia sensor aperture (left justified)2.250 .200H reflective (black) mark width[3] 4.65 .500I distance between reflective marks[4] – .500J reflective mark length[4] – .100[1] Units of measure given in inches.[2] If the optional Light-Duty Cutter is attached, it must be aligned to only cut liner, wherethe thickness can be no greater than .005” (.127mm).[3] The reflective (black) mark must be carbon based, placed on the backside of the stock,and the reflectance shall be less than 10% at wavelengths of 950 and 640 nm.[4] The maximum allowable length of the combined label and gap (or mark) measurementcan not exceed 99.99 inches.Approved MediaTo achieve optimum print quality and maximum printhead life, DATAMAXbrand media and ribbons are recommended. These supplies are speciallyformulated for use in this printer. The use of non-Datamax supplies may affectthe print quality, performance, and life of the printer or its components (see theWarranty Statement). Consult Section 2.1 for an overview of the different mediaand ribbon types. For a current list of approved media and ribbons, contact aMedia Representative at (407) 523-5650.