I-Class 193.1.2 Fan-Fold MediaThis loading method is for tag and fan-fold type media applications. To load:å Bring the media in through the Bottom or the Rear Media Slot. (If usingreflective stock, ensure that the mark is facedown.)ç Depending upon the entry point, route the media as shown: if through theRear Media Slot, route the media over the Media Hub; or, if through theBottom Media Slot, route the media over the Media Rewind Hub.é Continue routing the media under the Media Idler, through the MediaSensor and out the front of the printer.è Raise and slide the Media Guide over until it rests lightly against the edgeof the media.ê Position the Media Sensor; see Section 3.2.ë If your application uses thermal transfer media, load ribbon (see Section3.3); otherwise continue.í Lower the Printhead Assembly and rotate the Printhead Latch completelyback into the locked position. Close the Access Cover.ì Turn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEEDKey until at least one label gap or mark is advanced; see Section 3.4.+ If using less than full width media, adjust the Leveling Cam; seeSection 5.1.1.
