3-32 Xerox Internal Use Only Phaser 3010/3040/WorkCentre 3045 ServiceImage QualityTest PrintsA variety of test prints are available for troubleshooting print quality defects andto confirm proper printer operation. Test Prints can isolate printing problems to theMCU or Image Processor Board by using on board image data to isolate the twoboards. Test prints are also useful for stimulating asynchronous (dynamic) eventsrelated to the print process, or as a test for media path and media relatedproblems. Some other key features of test prints:• Is the only diagnostic utility to exercise the entire print cycle.• They are isolated from the operating system, and are run from firmware.• Isolates the Image Processor Board from the MCU Board.• Captures static or dynamic events.• Helps to isolate events that cause print artifacts or prevents printing.Test prints are selected from the list of available test prints in the Test Print menuof diagnostics.Printing Test Prints From CE Diagnostics1. Start the CE Diagnostic software, and select the CE Diags tab.2. Select Test Print.3. Select the desired test print button.Printing Test Prints From Service Diagnostics1. Power off the printer.2. Power on the printer while pressing the Down Arrow and Up Arrow buttons.3. Release the fingers from the buttons when “CE Mode” and “Password” isdisplayed.4. Press the Down Arrow button twice and press OK button.The printer is now in Service Diagnostic mode.5. Press the Down Arrow button until “Test Print” is displayed.6. Press OK.7. Use the Down Arrow and Up Arrow buttons to select the desired test print.Paper SizeSets the paper size in which the test print is printed.
