4-86 Xerox Internal Use Only Phaser 3010/3040/WorkCentre 3045 ServiceService Parts DisassemblyWorkCentre 3045 XerographicsXerographics AssemblyThis procedure removes the developer and xerographic housings as a single unit.PL3.1.51. Remove the Main Tray (page 4-58).2. Remove the Front Cover (page 4-60).3. Remove the Inner Front Cover (page 4-62).4. Remove the Left Cover (page 4-64).5. Remove the Right Cover (page 4-57).6. Remove the Scanner (page 4-109).7. Disconnect P/J7601 from the Front USB Board.8. Disconnect P/J6501 from the WiFi Adaptor.9. Remove the Top Cover (page 4-52).10. Remove the Rear Cover (page 4-11).11. Remove the Toner Motor (page 4-37).12. Remove the Toner Dispense Assembly (page 4-36).13. Remove the Fuser (page 4-38).14. Remove the MCU Board (page 4-43).15. Remove the HVPS (page 4-98).16. Remove the Power Switch Assembly (page 4-46).17. Remove the LVPS (page 4-48).18. Remove the LVPS bracket (page 4-107).19. Remove the Rear Door Interlock Switch (page 4-44).20. Remove the IP Board (page 4-45).21. Remove the Fax Board if present (page 4-105).22. Remove the IP Board bracket (page 4-106).23. Remove the Main Drive Assembly (page 4-40).24. Remove the Main Drive Motor (page 4-41).
