Phaser 3010/3040/WorkCentre 3045 Service Xerox Internal Use Only 1-25General InformationFirst Print Output TimeFirst Print Output Time (FPOT) is defined as a time from when the engine receivesa Start signal in Ready state, until a single page is delivered to the output tray.The following conditions are applied:• The Controller does not keep the print engine waiting• The printer is at Ready mode• Paper is A size Short Edge Feed (SEF)• Process control time is not includedFirst Copy Output TimeFirst Copy Output Time (FCOT) is the time required for the printer to deliver thefirst sheet of paper after the user presses Start. The following conditions areapplied:• The Controller does not keep the print engine waiting• The printer is at Ready mode• Paper is A size Short Edge Feed (SEF)• The original is on the document glass or in the ADF• Process control time is not includedIIT The Scanner and ADF are in standby,ready to run.Control PanelOperationLCD - Backlight: OnLED: If printer is online, Ready LED is On.Power SaverMode (DeepSleep)The printer enters Power Saver modewhen it has not received print data for thespecified time.Recording The system is at Pause.Fusing The system is Off.IIT The Scanner and ADF are off.Control PanelOperationLCD: Off, LCD Backlight: OffLED: Wake Up LED is On.NOTE When the printer receives a print or Fax job or the Wake Up/Power Saver button is pressed,the printer exits the Power Saver mode and enters the Ready mode.Mode Tray FPOT (sec.)Mono Main 12.0 sec. or lessBypass 12.0 sec. or lessMode FCOT (sec.)Mono 23.0 sec. or lessMode Condition Description
