LLooaaddiinngg TTaabb SSttoocckk iinn TTrraayyss 33 aanndd 441. Select the appropriate paper for your print job.2. Pull out the tray slowly until it stops.3. Before loading the tab stock into the tray, fan the tab stock.4. Load and align the edge of the tab paper against the right edge of the tray, with the side to becopied or printed facing down.5. To adjust the paper guides, press in the guide release and move the edge guide carefully until ittouches the edge of the media in the tray.Do not load media above the Max line on the rear edge guide.6. Gently push in the tray until it stops.If enabled by your system administrator, the Paper Tray settings screen appears on the touchscreen.7. If you made changes to the paper tray, touch Change Settings. If you did not make anychanges, proceed to the next step.a. For Paper Type / Paper Weight, Paper Size, and Paper Color, select options as needed.b. If necessary, make changes to the paper curl and alignment adjustment options.Note: For detailed information on the paper curl and alignment adjustment options,refer to the Xerox®® PrimeLink®® B9100/B9110/B9125/B9136 Copier/Printer SystemAdministrator Guide.c. Touch Save on each screen until you return to the tray settings window.8. Touch Confirm.LLooaaddiinngg HHoollee--PPuunncchh PPaappeerr iinn TTrraayyss 11,, 22,, 33,, aanndd 441. Select the appropriate paper for your print job.2. Pull out the tray slowly until it stops.3. Open the ream of paper with the seam side facing up.4. Before loading paper into the tray, fan the sheets of paper.5. Load the hole-punch paper against the left edge of the tray.Align the paper so that the holes are against the left edge of the tray, and ensure that the paperis loaded in the Long Edge Feed (LEF) orientation.166 Xerox® PrimeLink® B9100/B9110/B9125/B9136 Copier/PrinterUser GuidePaper and Media