Curl Correction on the Interface DecurlerModuleTip: The purpose of curl correction is to adjust paper curl as the paper leaves the printer, butbefore the paper reaches the next inline finishing device. Use the Interface Decurler Module(IDM) paper curl-correction feature while the printer is printing.1. Printed media from the printer2. Interface Decurler Module paper path3. Printed media from the Interface Decurler Module to inline finishing deviceAs media enters the module, it moves to the decurler for curl correction. The decurler has a decurlerroll that applies pressure to the media, based on the following:• System default: Auto is on.• Manual selections made from the IDM control panel.If you want to quickly adjust the media curl on the printed output, use the manual curl-up or curl-down buttons. If the printed output contains too much curl after you use these buttons, for moreadjustment information, refer to Curl Correction Modes and Functions on the Interface DecurlerModule.From the decurler, the printed media is cooled and routed from the Inserter Decurler Module to thenext inline finishing device that is connected to the printer.CCuurrll CCoorrrreeccttiioonn MMooddeess aanndd FFuunnccttiioonnss oonn tthheeIInntteerrffaaccee DDeeccuurrlleerr MMoodduulleeNote: When you select an Interface Decurler Module (IDM) curl-correction mode, the newmode is applied to the next sheet that is delivered to the IDM.304 Xerox® PrimeLink® B9100/B9110/B9125/B9136 Copier/PrinterUser GuideInterface Decurler Modules