Xerox WorkCentre 7132 System Administration Manual

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

Xerox WorkCentre 7132 System Administration Guide 10910 USB PortThis chapter explains how to set up the machine in a USB port environment. Thefollowing information is provided.Information Checklist – page 109USB Port Environment – page 110USB Port Installation – page 110Installation Procedure – page 110USB Port Communication Setup – page 111Workstation Setup – page 111Test Print – page 112Information ChecklistBefore starting the USB port installation procedures, make sure that the following itemsare available or have been performed.NOTE: The installation procedures will install the machine on the USB port of the hostworkstation. The procedures are not intended to connect the host workstation to otherworkstations.If problems are encountered during the installation of the machine, refer to the ProblemSolving chapter for assistance.CAUTION: Do not connect the USB cable to the machine until instructed to doso.Item ByUSB Cable CustomerTest the machine to make sure that it is installed fully and functioningcorrectly.CustomerInstall the print driver. Customer