Scan to SMB SetupXerox WorkCentre 7132 System Administration Guide 135Procedure for Scan to FTP1. On the control panel, select [Scan to FTP].2. Enter all the information required. See the User Guide for more detailedinformation.3. Load a sample document into the document feeder.4. Press the button on the machine.5. Logon to the FTP server. Navigate to the directory path (repository) that was setup earlier on the server. Your scanned document can be found in the specifieddirectory.NOTE: If Kerberos authentication (remote authentication) has been enabled, aseparate login screen appears when the Scan to FTP feature is selected. Documentsare not scanned in unless the Kerberos server authenticates user access.Scan to SMB SetupFiles can be scanned on the multifunction machine and routed on to a server or a clientusing SMB protocol. Directory structures (repositories) need to be created on theserver to hold the scanned documents.Prerequisites for Scan to SMB Setup1. Confirm that an existing operational network utilizing TCP/IP is available.2. SMB Server exists and is running.3. Repository (folder) needs to be created on the SMB server to hold the scanneddocument.4. Confirm that the following ports are enabled:1) TCP/IP Port2) SMB PortData to Set Up Scan to SMB InstallRequirement CommentsServer IP address Required This is the IP address of the SMB server.Server Shared Name Required This is the name assigned to the sharedfolder on the SMB server.Repository – directory path, wherethe document will be stored on theSMB serverRequired This is the location or path of the directory forsaving scanned documents.
