4 CentreWare Internet Services54 Xerox WorkCentre 7132 System Administration Guide• Auto Master Mode – Allows you to enable or disable (on/off) Auto Master Mode.• Password Encryption – Allows you to enable or disable password encryptionduring SMB transmission.5. Select [Apply] to reflect the new setting.6. Enter the user ID and password then select [OK].NOTE: The default user ID is "11111" and the default password is "x-admin".7. When the reboot message appears, select [Reboot Machine].NOTE: For more information about the contents of items, refer to the CentreWareInternet Services chapter of the User Guide.NetWareThis page allows you to configure the NetWare settings for the following options.NOTE: Some settings on this page will only be available after you restart CentreWareInternet Services, or after the machine is switched off and on.1. At the CentreWare Internet Services home page for the machine, select the[Properties] tab.2. In the [Properties] frame, select the plus symbol [+] to the left of the [ProtocolSettings] folder.3. Select [NetWare].4. Set up the following options to be displayed in the frame.General:• Host Name – Enter the host name.• Active Mode – Selects the Active Mode for the printer when using NetWare.• File Server Name – Enter the file server name.• Polling Interval – Allows you to set the time interval from when print data enterthe print queue until printing starts.• Number of Searches – Enter the maximum number of searches.• Password – Enter the print server (PServer) password.• Re-enter Password – Allows you to verify the PServer password by re-enteringthe same password.• TBCP Filter – (Only available when the optional PostScript Kit is installed.)NDS:• Tree Name – Enter the tree name.• Context Name – Enter the context name of the Print Server.Transport Protocol (IPX/SPX):• Frame Type – Select the frame type (Auto, Ethernet II, Ethernet 802.3, Ethernet802.2, Ethernet SNAP).