Xerox WorkCentre 7132 System Administration Manual

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

5 NetWare70 Xerox WorkCentre 7132 System Administration Guide2. Display the [System Settings] screen.NOTE: For more information about how to display the [System Settings] screen, referto the Setups chapter of the User Guide.3. Select [Network Settings].4. Select [Port Settings].5. Select [NetWare], then [Change Settings].6. Select [Port Status], then [Change Settings].7. Select [Enabled], then [Save].Next, establish TCP/IP if you use IP Address for a NetWare network.1. Display the [System Settings] screen.NOTE: For more information about how to display the [System Settings] screen, referto the Setups chapter of the User Guide.2. Select [Network Settings].3. Select [Protocol Settings].4. Select [TCP/IP – Get IP Address], then [Change Settings].5. Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],[DHCP/Autonet], or [Manual], and then select [Save].NOTE: Use the DHCP server together with the Windows Internet Name Server(WINS) server.If you selected [Manual] in step 5, then complete step 6 to 11 to enter the [ProtocolSettings]. Otherwise, complete step 14.6. Select [TCP/IP - IP Address], then [Change Settings].7. Use the keypad on the screen to enter the IP Address for the machine in theformat “xxx.xxx.xxx.xxx”. Enter relevant values (0 to 255) into the highlighted fieldand select [Save/Next]. The next 3 digits are highlighted. When you have finishedentering all values, select [Save].8. Select [TCP/IP - Subnet Mask], then [Change Settings].9. Using the same method as in step 7, enter the Subnet Mask.10. Select [TCP/IP - Gateway Address], then [Change Settings].11. Using the same method as in step 7, enter the Gateway Address.NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.12. Select [TCP/IP - IP Filter], then [Change Settings].13. Select [On] to filter access to the machine.NOTE: If you do not wish to use the IP filter feature, select [Off].