-C OptionXerox WorkCentre 7132 System Administration Guide 91NOTE: If several parameters are specified in the first lpr command, data may not print.NOTE: For some print languages, the color parameter may be invalid.NOTE: The system default is used if no parameter is specified.Specifying staplingThe following parameters can be specified for stapling.NOTE: If several parameters are specified in the first lpr command, data may not print.NOTE: For some print languages, the stapling parameter may be invalid.PrintingTo specify the output format of printing, enter the following command:-C,[parameter],[parameter]Enter a “,” (comma) after -C followed by the parameters which specify the outputformat. To specify multiple parameters, separate them with “,”.For example, to print a file named “file1”, two-sided on A4 (210 × 297 mm/8.3 × 11.7inches) on printer fxPS, enter the following command:%lpr -PfxPS -C,DUP,A4 file1CB/cb Selects color for color mode and speed priority for print mode.GC/gc Selects monochrome for color mode and quality priority for print mode.GB/gb Selects monochrome for color mode and speed priority for print mode.AC/ac Selects auto (color/monochrome) for color mode and quality priority forprint mode.AB/ab Selects auto (color/monochrome) for color mode and speed priority forprint mode.Parameter DescriptionSTAPLETL Places one staple in the upper left corner of the prints.STAPLETD Places two staples at the top of the prints.STAPLETR Places one staple in the upper right corner of the prints.STAPLELD Places two staples on the left side of the prints.STAPLERD Places two staples on the right side of the prints.STAPLEBL Places one staple in the lower left corner of the prints.STAPLEBD Places two staples at the bottom of the prints.STAPLEBR Places one staple in the lower right corner of the prints.Parameter Description
