Xerox WorkCentre 7132 System Administration Manual

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

15 Problem Solving146 Xerox WorkCentre 7132 System Administration GuideRestrictionsThis section explains the restrictions that apply while using SMB.Machine settings• The IP address is a unique address administered system-wide. Consult with thenetwork administrator when setting the necessary parameters.• The subnet mask and gateway settings may also be required, depending on thenetworking environment. Consult with the network administrator when setting thenecessary parameters.• When a port status is enabled and there is insufficient memory, the port status maybe disabled automatically. In this case, disable all unused ports and reallocate thememory.• The [Receiving Buffer - SMB Spool] memory allocation needs to be set in responseto the operating environment. If the memory allocation is too small, it may preventreceiving messages.Client settings• The IP address is a unique address administered system-wide. Consult with thenetwork administrator when setting the necessary parameters.• Consult with the Network Information Service (NIS) administrator when setting upthe network parameters (IP address and other parameters) from a host running NIS.When the machine is switched offThe following actions take place when the machine is switch off.• When [Receiving Buffer - SMB Spool] is set to [Memory]:All print data spooled in machine memory, including the data currently being printed,is deleted. There is no print data on the machine when the machine is subsequentlyswitched on.However, if the machine is switched off immediately after a print request, the printdata may be stored on the client. In this case, the print request can be reissued whenthe machine is subsequently turned on, and the print data is printed on the machinein turn.• When [Receiving Buffer - SMB Spool] is set to [Hard Disk]:All print data spooled on the machine hard disk, including the data currently beingprinted, is retained. A print request can be reissued when the machine issubsequently turned on, and the print data is printed on the machine in turn.• When [Receiving Buffer - SMB Spool] is set to [Off]:All print data in the receiving buffer, including the data currently being printed, isdeleted. There is no print data on the machine when the machine is subsequentlyswitched on.However, if the machine is switched off immediately after a print request, the printdata may be stored on the client. In this case, the print request can be reissued when