5 NetWare68 Xerox WorkCentre 7132 System Administration GuideNetWare EnvironmentsSystem configurationThe machine supports NetWare PServer mode in Bindery or NDS. NetWare 3.x/4.x/5.x/6.x is required to support Bindery. NetWare 4.11 or later is required to support NDS.In the PServer mode, the machine will function as a print server and print jobs from theprint queue. The machine uses one file server user license.NOTE: The machine does not support RPrinter mode.Target computersThe NetWare versions and NetWare client computers require the followingenvironments.NetWare versionsA Novell-accredited computer which can be installed with NetWare 3.x/4.x/5.x/6.x.NetWare client computersA Novell-accredited computer which can run Windows 95, Windows 98, Windows ME,Windows NT 4.0, Windows 2000, Windows XP or Windows Server 2003.NOTE: When using the LPD port by Novell Distributed Print Services (NDPS), activatethe LPD port on the machine and set the IP address.IPX/SPX frame typesThe machine supports the following Ethernet interfaces.• 10Base-T (Twisted Pair Cable)• 100Base-TX (Twisted Pair Cable)The machine supports the following frame types.• Ethernet II specification• IEEE802.3 specification• IEEE802.3/802.2 specification• IEEE802.3/802.2/SNAP specificationThe machine will send out packets of each frame type on the connected network. It willautomatically use the frame type which corresponds to the first response. However, ifmore than one protocol is running simultaneously on the same network, the machinewill use the same frame type as used by the NetWare server.NOTE: Some network components, such as the hub may not support automatic frametype setup. If the data link indicator light of the port does not light up, match the IPX/SPX setting of the frame type of the machine, to the frame type of the file server.
