Using CentreWare Internet Services to Configure Settings on the MachineXerox WorkCentre 7132 System Administration Guide 53EtherTalkThis is only displayed when PostScript Kit is installed. This page allows you to configurethe EtherTalk settings.NOTE: Some settings on this page will only be available after you restart CentreWareInternet Services, or after the machine is switched off and on.1. At the CentreWare Internet Services home page for the machine, select the[Properties] tab.2. In the [Properties] frame, select the plus symbol [+] to the left of the [ProtocolSettings] folder.3. Select [EtherTalk].4. Set up the following options to be displayed in the frame.• Printer Name – Enter the printer name for EtherTalk.• Zone Name – Enter the EtherTalk zone name.5. Select [Apply] to reflect the new setting.6. Enter the user ID and password then select [OK].NOTE: The default user ID is "11111" and the default password is "x-admin".7. When the reboot message appears, select [Reboot Machine].NOTE: For more information about the contents of items, refer to the CentreWareInternet Services chapter of the User Guide.SMBThis page allows you to configure the SMB settings for the following options.NOTE: Some settings on this page will only be available after you restart CentreWareInternet Services, or after the machine is switched off and on.1. At the CentreWare Internet Services home page for the machine, select the[Properties] tab.2. In the [Properties] frame, select the plus symbol [+] to the left of the [ProtocolSettings] folder.3. Select [SMB].4. Set up the following options to be displayed in the frame.• Workgroup – Enter the workgroup name.• Host Name – Enter the host name.• Maximum Sessions – Allows you to specify the maximum number of sessions.• TBCP Filter (Only available when the optional PostScript Kit is installed.)• Unicode Support – Allows you to specify whether to enable Unicode support inthe host name and workgroup name during SMB transmission.