Yamaha FJR 1300 AE 2014 Service Manual

FRONT BRAKE4-462. Remove:• Brake caliper3. Install:• Brake pads• Brake pad springs• Brake pad bolts• Brake caliper• Brake hose holderRefer to “REPLACING THE FRONT BRAKEPADS” on page 4-43.4. Fill:• Brake master cylinder reservoir• Brake fluid reservoir(with the specified amount of the specifiedbrake fluid)WARNINGEW3P61008• Use only the designated brake fluid. Otherbrake fluids may cause the rubber seals todeteriorate, causing leakage and poorbrake performance.• Refill with the same type of brake fluid thatis already in the system. Mixing brake fluidsmay result in a harmful chemical reaction,leading to poor brake performance.• When refilling, be careful that water doesnot enter the brake master cylinder reser-voir and brake fluid reservoir. Water willsignificantly lower the boiling point of thebrake fluid and could cause vapor lock.NOTICEECA13540Brake fluid may damage painted surfacesand plastic parts. Therefore, always clean upany spilt brake fluid immediately.5. Bleed:• Brake systemRefer to “BLEEDING THE HYDRAULICBRAKE SYSTEM (ABS)” on page 3-15.6. Check:• Brake fluid levelBelow the minimum level mark “a” → Add thespecified brake fluid to the proper level.Refer to “CHECKING THE BRAKE FLUIDLEVEL” on page 3-14.7. Check:• Brake lever and brake pedal operationSoft or spongy feeling → Bleed the brake sys-tem.Refer to “BLEEDING THE HYDRAULICBRAKE SYSTEM (ABS)” on page 3-15.EAS22490REMOVING THE FRONT BRAKE MASTERCYLINDERTIPBefore removing the front brake master cylinder,drain the brake fluid from the entire brake sys-tem.1. Remove:• Brake hose union bolt “1”T R..Brake pad bolt17 Nm (1.7 m·kg, 12 ft·lb)Brake caliper bolt40 Nm (4.0 m·kg, 29 ft·lb)Brake hose holder bolt7 Nm (0.7 m·kg, 5.1 ft·lb)Specified brake fluidDOT 44a3ab41b2A. Front brakeB. Unified brake system