Yamaha FJR 1300 AE 2014 Service Manual

IMMOBILIZER SYSTEM8-122* Accessory locks mean the seat lock and fuel tank cap.Code re-registering key registration:When the immobilizer unit or ECU is replaced, the code re-registering key must be registered to theunit.To register a code re-registering key:1. Turn the main switch to “ON” with the code re-registering key.TIPCheck that the immobilizer system indicator light comes on for one second, then goes off. When theimmobilizer system indicator light goes off, the code re-registering key has been registered.2. Check that the engine can be started.3. Register the standard key, following the instructions in the section below.Standby mode:To enable the immobilizer system, turn the ignition key to “OFF”. 30 seconds later, the indicator lightwill start flashing continuously in the standby flashing mode pattern for up to 24 hours. After that time,the indicator light will stop flashing, but the immobilizer system is still enabled.Parts to be replacedKey registration re-quirementMain switch/immo-bilizer unit Standardkey ECUAccesso-ry lock*and keyMainswitchImmobiliz-er unitStandard key is lost √ New standard keyAll keys have beenlost (including codere-registering key)√ √ √ √Code re-registeringkey and standardkeysECU is defective √Code re-registeringkey and standardkeysImmobilizer unit isdefective √Code re-registeringkey and standardkeysMain switch is defec-tive √ √ √ √Code re-registeringkey and standardkeysAccessory lock* isdefective √ Not required