Yamaha FJR 1300 AE 2014 Service Manual

ELECTRONICALLY ADJUSTABLE SUSPENSION SYSTEM8-1859 Malfunction in SCU. Replace the SCU. Execute the diagnostic mode(code No. 84). Service is fin-ished.10 Engagement of the preloadadjusting pump shaft.Remove the preload adjust-ing pump, turn the pumpshaft to the proper position,install the pump, and thenexecute the diagnostic mode(code No. 84).Refer to “ADJUSTING THEREAR SHOCK ABSORBERASSEMBLY DC MOTOR” onpage 4-100.Execute the diagnostic mode(code No. 84).“00” is displayed → Serviceis finished.“F0” is displayed → Go toitem 11.11 Defective rear shock absorb-er assembly.Replace the rear shock ab-sorber assembly.Execute the diagnostic mode(code No. 84). Service is fin-ished.Fault code No. 95Item Defective preload adjusting motor (DC motor).Fail-safe system Able to start engineAble to drive vehicleDiagnostic code No. 84Meter displayWhen completed successfully:“00” is displayed in the multi-function meter right display and theelectronically adjustable suspension system warning light goes off.The preload is adjusted to the solo-riding position.When not completed successfully:“F0” is displayed in the multi-function meter right display and theelectronically adjustable suspension system warning light remainson. Remove the rear shock absorber assembly DC motor and ad-just it by hand.After adjusting the DC motor, perform the procedure for diagnosticcode No. 84 again. If “F0” is displayed again, replace the rearshock absorber assembly.Procedure To adjust the preload home position, simultaneously press the“TCS” button and “RESET” button for 2 seconds.Item Probable cause of mal-function and check Maintenance job Confirmation of servicecompletionFault code No. 94ItemPreload adjusting motor (rear shock absorber assembly DCmotor) is locked, rotary encoder signal is not received, encod-er signal is reversed, or motor rotates continuously at a lowspeed during the diagnostic mode (code No. 84 [preload homeposition adjustment]).