Yamaha FJR 1300 AE 2014 Service Manual

TIGHTENING TORQUES2-26TIPLower ring nut1. First, tighten the lower ring nut to approximately 52 Nm (5.2 m·kg, 37 ft·lb) with a torque wrench, thenloosen the lower ring nut completely.2. Retighten the lower ring nut to 18 Nm (1.8 m·kg, 13 ft·lb) with a torque wrench.TIPBrake hose joint bracket boltTo install the front brake hose joint, tighten the bolts in the proper tightening sequence.1. Tighten the bolts temporarily in the proper tightening sequence.2. Tighten the union bolt “2” to 30 Nm (3.0 m·kg, 22 ft·lb) and the bolt “3” to 7 Nm (0.7 m·kg, 5.1 ft·lb).3. Tighten the front brake hose joint bolt “1” to 7 Nm (0.7 m·kg, 5.1 ft·lb).TIPFront wheel axle pinch bolt1. Insert the front wheel axle from the right side and tighten it with the front wheel axle bolt from the leftside to 91 Nm (9.1 m·kg, 66 ft·lb).2. In the order pinch bolt “2” → pinch bolt “1” → pinch bolt “2”, tighten each bolt to 21 Nm (2.1 m·kg, 15ft·lb) without performing temporary tightening.3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push thefront axle or lightly tap it with a soft hammer until its end is flush with the front fork. However, if thesurface of the front axle end is not parallel to the surface of the front fork, align a point on the outeredge of the axle with the fork, making sure that the axle does not protrude past the fork.Coupling gear nut M16 1 110 Nm (11.0 m·kg, 80 ft·lb) StakeRing gear bearing housing bolt M10 2 40 Nm (4.0 m·kg, 29 ft·lb)Ring gear bearing housing nut M8 6 23 Nm (2.3 m·kg, 17 ft·lb)Final gear case stud bolt M8 6 9 Nm (0.9 m·kg, 6.5 ft·lb)Ring gear bearing housing stop-per bolt M10 1 9 Nm (0.9 m·kg, 6.5 ft·lb) Left-handthreadECU cover bolt M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)Electrical components tray bolt M6 4 10 Nm (1.0 m·kg, 7.2 ft·lb)Battery holder bolt M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)Air guide bolt M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)Horn bolt M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)Rectifier/regulator stay bolt M6 3 7 Nm (0.7 m·kg, 5.1 ft·lb)Item Threadsize Q’ty Tightening torque RemarksLT132