Yamaha MBK MW125 2014 Service Manual

FEATURES1-5Clock[To set the clock]1. Push the “SELECT” button and “RESET” but-ton together for at least two seconds.2. When the hour digits start flashing, push the“RESET” button to set the hours.3. Push the “SELECT” button, and the minutedigits will start flashing.4. Push the “RESET” button to set the minutedigits.5. Push the “SELECT” button and then releaseit to start the clock.Outside air temperature display “OUTTEMP”This display shows the outside air temperaturefrom –10 °C to 40 °C in 1 °C increments. Thetemperature displayed may vary from the actualoutside air temperature.TIP• If the outside air temperature falls below –10°C, a lower temperature than –10 °C will not bedisplayed.• If the outside air temperature climbs above 40°C, a higher temperature than 40 °C will not bedisplayed.• The accuracy of the temperature reading maybe affected when riding slowly [approximatelyunder 20 km/h (12 mi/h)] or when stopped attraffic signals, railroad crossings, etc.Odometer and tripmeter modesPush the “SELECT” button to switch the displaybetween the odometer mode “ODO”, the tripme-ter modes “TRIP 1” and “TRIP 2”, the oil changetripmeter mode “OIL TRIP” and the V-belt re-placement tripmeter mode “BELT TRIP” in thefollowing order:ODO → TRIP 1 → TRIP 2 → OIL TRIP → BELTTRIP → ODOWhen approximately 1.6 L (0.42 US gal, 0.35Imp.gal of fuel remains in the fuel tank, the bot-tom segment of the fuel meter and fuel levelwarning indicator will start flashing, and the dis-play will automatically change to the fuel reservetripmeter mode “F” and start counting the dis-tance traveled from that point. In this case, push-ing the “SELECT” button switches the displaybetween the various tripmeter and odometermodes in the following order:F → TRIP 1 → TRIP 2 → OIL TRIP → BELTTRIP → ODO → FTo reset tripmeters 1, 2, or the fuel reserve trip-meter, select it by pushing the “SELECT” button,and then push the “RESET” button for at leastone second. If you do not reset the fuel reservetripmeter manually, it will reset itself automatical-ly and the display will return to the prior mode af-ter refueling and traveling 5 km (3 mi).To reset the oil change tripmeter or V-belt re-placement tripmeter, select it by pushing the“SELECT” button, and then push the “RESET”button for three to four seconds.1. Clock1. Outside air temperature display111. Odometer/tripmeters1